Download CCNP Implementing Cisco IP Routing (ROUTE v2-0).PracticeTest.300-101.2019-01-31.1e.457q.vcex

Download Dump

File Info

Exam Implementing Cisco IP Routing (ROUTE v2.0)
Number 300-101
File Name CCNP Implementing Cisco IP Routing (ROUTE v2-0).PracticeTest.300-101.2019-01-31.1e.457q.vcex
Size 20.57 Mb
Posted January 31, 2019
Downloads 526

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAM_HUB

Discount: 20%

 
 



Demo Questions

Question 1
Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

  • A: dual-stack method
  • B: 6to4 tunneling
  • C: GRE tunneling
  • D: NAT-PT



Question 2
Which statement about the use of tunneling to migrate to IPv6 is true?

  • A: Tunneling is less secure than dual stack or translation.
  • B: Tunneling is more difficult to configure than dual stack or translation.
  • C: Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.
  • D: Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.



Question 3
A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

  • A: IP routing
  • B: FIB
  • C: ARP cache
  • D: MAC address table
  • E: Cisco Express Forwarding table
  • F: topology table



Question 4
Which switching method is used when entries are present in the output of the command show ip cache?

  • A: fast switching
  • B: process switching
  • C: Cisco Express Forwarding switching
  • D: cut-through packet switching



Question 5
Which two actions must you perform to enable and use window scaling on a router? (Choose two.)

  • A: Execute the command ip tcp window-size 65536.
  • B: Set window scaling to be used on the remote host.
  • C: Execute the command ip tcp queuemax.
  • D: Set TCP options to "enabled" on the remote host.
  • E: Execute the command ip tcp adjust-mss.



Question 6
Refer to the exhibit. 

  

Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?

  • A: distribute list 1 out
  • B: distribute list 1 out FastEthernet0/0
  • C: distribute list 2 out
  • D: distribute list 2 out FastEthernet0/0



Question 7
Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?

  • A: 10.9.1.0/24
  • B: 10.8.0.0/24
  • C: 10.8.0.0/16
  • D: 10.8.0.0/23



Question 8
Router A and Router B are configured with IPv6 addressing and basic routing capabilities using oSPFv3. The networks that are advertised from Router A do not show up in Router B's routing table. After debugging IPv6 packets, the message "not a router" is found in the output. Why is the routing information not being learned by Router B?

  • A: OSPFv3 timers were adjusted for fast convergence.
  • B: The networks were not advertised properly under the OSPFv3 process.
  • C: An IPv6 traffic filter is blocking the networks from being learned via the Router B interface that is connected to Router A.
  • D: IPv6 unicast routing is not enabled on Router A or Router B.



Question 9
After you review the output of the command show ipv6 interface brief, you see that several IPv6 addresses have the 16-bit hexadecimal value of "fFFE" inserted into the address. Based on this information, what do you conclude about these IPv6 addresses?

  • A: IEEE EUI-64 was implemented when assigning IPv6 addresses on the device.
  • B: The addresses were misconfigured and will not function as intended.
  • C: IPv6 addresses containing "FFFE" indicate that the address is reserved for multicast.
  • D: The IPv6 universal/local flag (bit 7) was flipped.
  • E: IPv6 unicast forwarding was enabled, but IPv6 Cisco Express Forwarding was disabled.



Question 10
A packet capture log indicates that several router solicitation messages were sent from a local host on the Ipv6 segment. What is the expected acknowledgment and its usage?

  • A: Router acknowledgment messages will be forwarded upstream, where the DHCP server will allocate addresses to the local host.
  • B: Routers on the Ipv6 segment will respond with an advertisement that provides an external path from the local subnet, as well as certain data, such as prefix discovery.
  • C: Duplicate Address Detection will determine if any other local host is using the same Ipv6 address for communication with the Ipv6 routers on the segment.
  • D: All local host traffic will be redirected to the router with the lowest ICMPv6 signature, which is statically defined by the network administrator.









CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset