Download HCNA-HNTD (Huawei Network Technology and Device).Passcert.H12-211.2021-05-17.1e.417q.vcex

Download Exam

File Info

Exam HCNA-HNTD (Huawei Certified Network Associate-Huawei Network Technology and Device)
Number H12-211
File Name HCNA-HNTD (Huawei Network Technology and Device).Passcert.H12-211.2021-05-17.1e.417q.vcex
Size 15.61 Mb
Posted May 17, 2021
Downloads 10

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAM_HUB

Discount: 20%

 
 



Demo Questions

Question 1
When a router enabled with Proxy ARP function receives an ARP request packet and finds that the requested IP address is not its own, what actions are performed? (Multiple Choice)

  • A: If there is a route to the destination address, send its own MAC address to the ARP requester.
  • B: Discard the message
  • C: Broadcast ARP request message
  • D: Find if there is a route to the destination address or not



Question 2
Which of the following storage media are commonly used by Huawei routers? (Multiple Choice)

  • A: SDRAM
  • B: NVRAM
  • C: Flash 
  • D: Hard Disk
  • E: SD Card



Question 3
The VRP operating system commands are divided into four levels: access level, monitoring level, configuration level, and management level. Which level can run various business configuration commands but cannot operate the file system?

  • A: Access level
  • B: Monitoring level
  • C: Configuration level
  • D: Management level



Question 4
The switch MAC address table is existing as follows, which of the following statements is correct? 

    

  • A: The MAC address 5489-9885-1838 is manually configured by the administrator.
  • B: The MAC address 5489-9811-0b49 is manually configured by the administrator
  • C: The MAC address 5489-3891-1450 is manually configured by the administrator.
  • D: After the switch is restarted, all MAC addresses need to be re-learned.



Question 5
Compared to STP protocol, which kind of port role is added in RSTP protocol? (Multiple Choice)

  • A: Alternate port
  • B: Backup port
  • C: Root port
  • D: Designated port



Question 6
As shown in the figure, the two switches use the default parameters to run STP. On Switch A, the configuration command STP root primary is used. On the switch B, the configuration command STP priority 0 is used. Which of the following ports will be blocked?  

    

  • A: G0/0/2 of switch A
  • B: G0/0/1 of switch B
  • C: G0/0/1 of switch A
  • D: E0/0/3 of HUB



Question 7
Which of the following parameters does not the configuration BPDU packet of the STP protocol?

  • A: Port ID
  • B: Bridge ID
  • C: VLAN ID
  • D: Root ID



Question 8
By default, how many seconds are the Forward Delay of STP protocol?

  • A: 20
  • B: 15
  • C: 10
  • D: 5



Question 9
Which of the following parameters are used in the switched network that runs the STP protocol when performing spanning tree calculations? (Multiple Choice)

  • A: Root path cost
  • B: Port ID
  • C: Bridge ID
  • D: Forward Delay



Question 10
Both the two switches shown in the following figure have STP enabled. Which port will eventually be in the Blocking state?  

    

  • A: G0/0/2 port of SWA
  • B: G0/0/3 port of SWA
  • C: G0/0/2 port of SWB
  • D: G0/0/3 port of SWB 






CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset